Spark - Dyno DH

€360.00

DYNO DH Hardboot Binding

Delivery in December 2025. Pre-Order Now!

The Dyno DH is acclaimed hardboot specific splitboard binding. It is designed to fit a variety of touring boots from different brands and delivers high-end performance to the growing hardboot segment of splitboarders. All parts are designed and manufactured by Spark from start to finish for the all-around precision that you can only get from a Spark made product.

Dyno DH Bindings are for riding only. Carry them in your pack on the way up, while using your tech toes for touring. Then slide the Dynos on your pucks and lock into place with the snap ramps for the ride down.

Fits boots with 255 - 340mm sole length.

Weight: 0.90 lb/ea (409g) – 1.80 lb/pr (818g)

Compatibility and Setup

Spark Flat Puck compatible (Spark Canted Pucks recommended)

Also compatible with Spark Solid Board Flat Pucks and Canted Solid Board Pucks.

DYNO DH Hardboot Binding

Delivery in December 2025. Pre-Order Now!

The Dyno DH is acclaimed hardboot specific splitboard binding. It is designed to fit a variety of touring boots from different brands and delivers high-end performance to the growing hardboot segment of splitboarders. All parts are designed and manufactured by Spark from start to finish for the all-around precision that you can only get from a Spark made product.

Dyno DH Bindings are for riding only. Carry them in your pack on the way up, while using your tech toes for touring. Then slide the Dynos on your pucks and lock into place with the snap ramps for the ride down.

Fits boots with 255 - 340mm sole length.

Weight: 0.90 lb/ea (409g) – 1.80 lb/pr (818g)

Compatibility and Setup

Spark Flat Puck compatible (Spark Canted Pucks recommended)

Also compatible with Spark Solid Board Flat Pucks and Canted Solid Board Pucks.

FEATURES

Toe Clips

The toe clip is designed to fit even low profile AT boots. The slim design saves weight while maintaining backcountry dependability.

Set Screw

The set screw has a 4mm hex drive, found on our Spark Tool.

Lightweight & Strong

Stainless steel bails and anodized aluminum toe clips. The heel end of the baseplate has been reinforced to avoid bending with heavy use.

Snap Ramps

Tesla System Snap Ramps for speedy, pinless transitions.


What else do I need?

Pucks: A set of Spark Flat Pucks or Spark Canted Pucks (recommended for hardboot bindings)

Spark Tech Toes: A Spark original tech toe designed for the split-hardbooter. With its integrated splitboard touring bracket hole pattern, this tech toe doesn’t need a toe adapter, saving weight, unnecessary parts, and expense. It also has built-in claw mounts for the D Rex ST Pro crampon. The Spark Tech Toe is intended for splitboard touring only.

Hardboot Dual Height Wires: Made in-house by Spark R&D. 55mm and 75mm wires offer comfortable angles for any skin track. Comes with a heel adapter that screws right into your splitboard inserts, and places your dual height wires right where they need to be, hitting the perfect spot on the heel of your hardboot regardless of size.

D Rex ST Pro Crampons: Designed for our hardcore hardbooters, these crampons slide into tech toe claw mounts. Install and remove on the fly for utmost confidence in dicey conditions.

You Might Also Like